104418P SETHigh-speed steel HSS Co8DIN 844K
Clamping element
Type NR-F
Tool geometry
Feed direction possibility
Material HSS Co8
New
Set of end mills short, 1 tooth cut over centre, 35°, type NR-F, Weldon shank
Item codeOn stock
104418P.6-20 SET No

Content of set

104418P.6-20 SET

Item codeD
k 12
d
h 6
l1l2Z
104418P.0606657133
104418P.08081069193
104418P.100101072223
104418P.120121283263
104418P.160161692323
104418P.2002020104383

Cutting conditions


Material

Strength

Ap

Ae

Vc
fz(mm/z)
Ø 6

Ø 8

Ø 10

Ø 12

Ø 16

Ø 18

Ø 20

Ø 25

Ø 32
P.1 | Free-cutting steels, general construction steels≤ 600 N/mm²1,5xD0,5xD450.020.0250.0350.040.070.080.090.10.12
P.2 | General construction steels, steel castings≤ 850 N/mm²1,5xD0,5xD390.020.0250.0350.040.070.080.090.10.12
P.3 | Tool steels low alloyed≤ 1100 N/mm²1,5xD0,5xD240.020.0250.0350.040.070.080.090.10.12
P.4 | Heat treatable steels≤ 900 N/mm²1,5xD0,5xD300.020.0250.0350.040.070.080.090.10.12
P.5 | Tool steels high alloyed≤ 1100 N/mm²1,5xD0,5xD240.020.0250.0350.040.070.080.090.10.12
K.1 | Cast iron (≤ 240 HB)≤ 820 N/mm²1,5xD0,5xD350.020.0250.0350.040.070.080.090.10.12

Calculations of cutting conditions

Product attributes

Clamping element

Clamping element

more +
Straight shank with clamping flat (Weldon) according to DIN 1835 B.
Tool geometry

Tool geometry

more +
Helix angle = 35°. Rake angle = 12°.
Material HSS Co8

Material HSS Co8

more +
Extra high performance high speed steel with good toughness and great temperature resistance. It is applicable especially for milling of materials with high strength, austenitic steels, steels for warm working, etc.
Type NR-F

Type NR-F

more +
For machining of materials of lower and medium strength (up to 700 MPa), surface roughness Ra 3,2 and more, in common application can be applied as roughing and finishing tool at the same time.
Feed direction possibility

Feed direction possibility