104418PHigh-speed steel HSS Co8DIN 844K
Clamping element
Type NR-F
Tool geometry
Feed direction possibility
Material HSS Co8
End mills short, 1 tooth cut over centre, 35°, type NR-F, Weldon shank
k 12
h 6
l1 l2 Z Item codeOn stock
6657133104418P.060 Yes
81069193104418P.080 Yes
91069193104418P.090 Yes
101072223104418P.100 Yes
121283263104418P.120 Yes
141283263104418P.140 Yes
161692323104418P.160 Yes
181692323104418P.180 Yes
2020104383104418P.200 Yes
2220104383104418P.220 Yes
2425121453104418P.240 Yes
2525121453104418P.250 Yes
2625121453104418P.260 Yes
2825121453104418P.280 Yes
3025121453104418P.300 Yes
3232133533104418P.320 Yes

Cutting conditions





Ø 6

Ø 8

Ø 10

Ø 12

Ø 16

Ø 18

Ø 20

Ø 25

Ø 32
P.1 | Free-cutting steels, general construction steels≤ 600 N/mm²1,5xD0,5xD450.020.0250.0350.
P.2 | General construction steels, steel castings≤ 850 N/mm²1,5xD0,5xD390.020.0250.0350.
P.3 | Tool steels low alloyed≤ 1100 N/mm²1,5xD0,5xD240.020.0250.0350.
P.4 | Heat treatable steels≤ 900 N/mm²1,5xD0,5xD300.020.0250.0350.
P.5 | Tool steels high alloyed≤ 1100 N/mm²1,5xD0,5xD240.020.0250.0350.
K.1 | Cast iron (≤ 240 HB)≤ 820 N/mm²1,5xD0,5xD350.020.0250.0350.

Calculations of cutting conditions

Product attributes

Clamping element

Clamping element

more +
Straight shank with clamping flat (Weldon) according to DIN 1835 B.
Tool geometry

Tool geometry

more +
Helix angle = 35°. Rake angle = 12°.
Material HSS Co8

Material HSS Co8

more +
Extra high performance high speed steel with good toughness and great temperature resistance. It is applicable especially for milling of materials with high strength, austenitic steels, steels for warm working, etc.
Type NR-F

Type NR-F

more +
For machining of materials of lower and medium strength (up to 700 MPa), surface roughness Ra 3,2 and more, in common application can be applied as roughing and finishing tool at the same time.
Feed direction possibility

Feed direction possibility